Instructions for Angel Mark VII

Instructions for building:
Angel Mark VII

At last count, 32 people voted Angel Mark 7 as their favorite Legobot. Instructions are finally here! Enjoy.

Angel Mark 7- Instructions Index
1. The Arms	2. The Legs
3. The Head	4. The Body
5. Transformation

The Arms

1. Start with a 1x3 plate and a 2x2 inverted slant brick.
2. Add a 2x2 plate with a 1x1 brick piece.
3. Add a 1x2 brick, it doesn't have to be ridged. Also add a 1x4 girder and black peg as shown.
4. Add another 1x4 girder to the first one. Also, add a 1x4 plate to the bottom of the girder.
5. Add a 2x2 plate and a 1x1 brick to the end of the girder.
6. Put a 1x2 girder at the end. Place a 2x6 plate on the top and an extended peg in the girder's hole.
7. Add the shown pieces with a 2-long axel in each.
8. Add two of the pieces shown with two additional 2-long axels.
9. The last step is to add the pieces shown. The top one has a "3" on it, the bottom has a "5" on it. The claw is done.
10. Back at the top of the arm... add a hinge joint as shown.
11. Add a wing to the upper arm. A 2x3 plate can be added for show, it is not required.
12. Turn the arm over and add a jet engine. In the end of the engine, add an axle/peg piece.
13. Lastly, add a round 2x2 brick to the axle/peg.

Repeat the steps in mirror fashion to make the left arm.

Angel Mark 7- Instructions Index
1. The Arms	2. The Legs
3. The Head	4. The Body
5. Transformation

Index
Main Page	Guest Quarters
The Good: Guardians	Guardian Update!
The Bad: Destrons	Destron Update!
The Ugly: Junkbots	Junkbot Update!
Instructions	Tips and Tricks
The Ultra Throwbots	Links